HELP
Moderators: ddw, al wolford, sbk, Bob, Kayvon
-
- Posts: 1
- Joined: Tue Aug 16, 2011 5:36 pm
HELP
I recently purchased a Shark Pro Plus, I had everything installed just fine on my laptop, today I decided to purchase a new desktop to be used specifically for The Shark. Everything seemed to install ok from the Vectric software bundle, but when I tried to make a short cut for the CNC Shark Basic Control Panel, I found there wasnt even a file for it in my computer. How can I go about downloading the needed software and or program to get this set up?
Re: HELP
You need to download the panel and drivers from Next Wave Automation here:
http://www.nextwaveautomation.com/DownLoads.aspx
Scott
http://www.nextwaveautomation.com/DownLoads.aspx
Scott