control panel 2.1 & 4th axis

Everything 4th Axis

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
grazinghorse
Posts: 11
Joined: Mon Jun 06, 2016 8:12 am
Location: NW Missouri
Contact:

control panel 2.1 & 4th axis

Post by grazinghorse »

I just placed this tech support request to NWA. I'm running control panel 2.1 build 22.


When I set the head and the rear, then push the button to return to front, the gantry returns to the same point where I set the head. HOWEVER, I have noticed if I bump the mouse or deliberately slide the mouse off of the button DURING the gantry's return the gantry does not return to the precise point that I had initially set. It shifts towards the -x direction about 1/4 to 1/2 and inch.

Can you tell me if I am doing something wrong, or is this a software bug? It is not a big problem I just need to remember when I am going from rear to head not to touch the mouse until the gantry has returned completely.

Has anyone else encountered this?

Post Reply