Rounding toolpath

Everything 4th Axis

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
rpastor248
Posts: 3
Joined: Wed Jul 12, 2017 5:00 am

Rounding toolpath

Post by rpastor248 »

Greetings all,

I have used the wrapped job setup exactly as detailed in the tutorial. I have used the rounding gadget exactly as detailed in the tutorial. I saved it as a rotary tap. The machine is zeroed properly. 0,0,0 is at the beginning of the stock, on the center line of the stock, and at the center of the cylinder.

When I run the toolpath, runs in line with the side of the stock, rather than on the centerline.

It is probably something simple, but I can't figure out what. I have created plenty of rounding toolpaths and have never had this issue.

I need to get this fixed ASAP as I am in the middle of a much larger project.

Thanks for any help,

Bob

Post Reply