4th Axis Ignored Lines
Posted: Tue Jul 24, 2018 4:35 pm
Hi everyone, I am new to the forum and new to CNC. We just picked up a Shark HD4 Extended with the water cooled spindle and the 4th axis attachment. It has been a blast getting to use and running different pieces through it.
But I am running into an issue.... When I am working on projects that uses the 4th axis, once my file finishes running on the CNC it has "ignored" quite a few lines and the project shows it. I am not sure if this is something with VCarve, Post Processor, Gcode, or the Shark Computer.
Has anyone had this issue as well? Have you found a solution?
Thank you!
Mitch
But I am running into an issue.... When I am working on projects that uses the 4th axis, once my file finishes running on the CNC it has "ignored" quite a few lines and the project shows it. I am not sure if this is something with VCarve, Post Processor, Gcode, or the Shark Computer.
Has anyone had this issue as well? Have you found a solution?
Thank you!
Mitch