Tapered Work Piece Question
Moderators: al wolford, sbk, Bob, Kayvon
Tapered Work Piece Question
Can the standard 4th axis (or the VCarve software) be set up to handle a work piece that tapers from larger to smaller diameter?
-
- Posts: 77
- Joined: Mon Aug 17, 2020 3:47 pm
- Location: Ozark Mo
- Contact:
Re: Tapered Work Piece Question
I don't have the hardware for this nor have I done it. But I have seen 4th axis videos on youtube that have Aspire / Vcarve videos doing this. If my memory is correct. I didn't tag them but look on youtube for them.