Greetings. Every once in a while I get the I saw this on ....can you make it?
This was a picture of old wine barrel staves one up one down with cut outs to hold tea candles.
As I didn’t have any wine barrels laying around I went to Home Depot and bought a doug fir 4x4. Did the calculations on how big a radius would fit in a 3.5 x 30” window, avoided as many knots as I could and cut two of these out on my band saw.
I cleaned them up mostly with a spoke shave and a little with a rasp.
Then it came to how do I add five indents for the candles? Tried a couple on the scrap with a chisel and gouge, forsner bit and nothing looked good. So on to aspire to create a beautiful indent. Now how do I cut this beast in my shark?
Pictures are worth 1000 words. Save the waste pieces ‘til the job is done.
Can you make...Wavy barrel staves candle holders
Moderators: al wolford, sbk, Bob, Kayvon
Re: Can you make...Wavy barrel staves candle holders
Thanks for sharing this Bill. Another great example of 'can you make'....
Re: Can you make...Wavy barrel staves candle holders
Thanks Joe. Here’s a couple of shots of the finished product.