from the Vectric file.
Roughing - .25" 4 flute end mill, Pass/Step 0.1 40%, 12000 rpm at 60 imp
Finish - .125" 4 flute tapered ball nose, Stepover 0.01 10%, 12000 rpm at 75
Cut depth of .30
8x16 wild cherry, sealed then lightly glazed and 3 coats of lacquer over that.
I ran into a problem with the first settings on the finish pass. Set at 8% it threw an error at 98% while loading the Gcode but loaded fine when I upped it to 10% and dropped 40 or 50,000 lines of code so I'll be shopping for a new SD card.
Last Supper
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 488
- Joined: Fri Apr 08, 2011 2:14 pm
Re: Last Supper
Real nice job Karen.I like it.Basecircle
-
- Posts: 584
- Joined: Sun Jan 15, 2012 6:46 pm
- Location: North Little Rock, Arkansas
Re: Last Supper
Good job, lots of detail.
Being retired is hard work. Spending way too much time in the shop these days. (And loving it).
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.