Did this on a piece of pallet board. Had to steer clear of nail heads. My hand on the "Red Button" just in case.
Thanks again to all who post on this forum. I learn a lot from you guys. Having a blast.
Not my first but close.
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 584
- Joined: Sun Jan 15, 2012 6:46 pm
- Location: North Little Rock, Arkansas
Re: Not my first but close.
Pretty cool. Now a raggid end and a knot hole or two.......
Being retired is hard work. Spending way too much time in the shop these days. (And loving it).
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.