Another segmented bowl
Moderators: al wolford, sbk, Bob, Kayvon
Another segmented bowl
41 pieces of walnut and birch. 10 sides. I wanted 10 sides because this would be a challenge for someone without a CNC. Probably should have done an odd number to make it even more challenging for someone without a CNC.
Walnut dowel in the middle to stabilize during milling. Also hid the small defects in the middle. Milled the center and sides on the CNC. Then over to router table with bowl bit and flush trim bit to finish it off. . Used nesting feature and kept all pieces perpendicular to the grain. Used only a couple of scrap pieces from my shop.
-
- Posts: 488
- Joined: Fri Apr 08, 2011 2:14 pm
Re: Another segmented bowl
Very nice.Another way to use the shark.Good Job Basecircle
Re: Another segmented bowl
I have been looking at this one for weeks and I cannot work out how it was done
Regards
LW
Regards
LW
If you can't blind someone with science, Confound then with B***S***