Wanted to see if I could carve this insignia (VectorArt) small (6")
Sold a few but not really worth the time involved.
attachment=0]DolphinsBolivianRosewood.png[/attachment]
Next stop Corian.[
Small Insignia
Moderators: al wolford, sbk, Bob, Kayvon
Re: Small Insignia
Nice job. I dont do much 3d because of the time involved. I think that it is hard to sell, considering the time involved unless it is incorporated into chests boxes and the like.
Re: Small Insignia
I am learning as I go along. New to CNC. I agree, too much time for these.
I am going to carve these in Corian with engraving so the price will be better.
I'll post when I have some Corian to show.
I am going to carve these in Corian with engraving so the price will be better.
I'll post when I have some Corian to show.
-
- Posts: 488
- Joined: Fri Apr 08, 2011 2:14 pm
Re: Small Insignia
Very nice carve.You got it down Basecircle
Re: Small Insignia
MarkB611
I think they look great. But that may be because I was on a sub. TM2SS USS Remora SS487 small world.
I think they look great. But that may be because I was on a sub. TM2SS USS Remora SS487 small world.
drueth
Shark Pro Plus HD
new to CNC 12/2012
Shark Pro Plus HD
new to CNC 12/2012
Re: Small Insignia
Thanks all.
drueth hello. I was MT2SS..
I sold a few but I already broke off the periscopes on 2. Too small.
drueth hello. I was MT2SS..
I sold a few but I already broke off the periscopes on 2. Too small.