My first carve
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 584
- Joined: Sun Jan 15, 2012 6:46 pm
- Location: North Little Rock, Arkansas
Re: My first carve
Good start. May be the angle, but to me, a little less depth of cut might be a little easier to read.
Being retired is hard work. Spending way too much time in the shop these days. (And loving it).
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.
Shark Pro Plus HD, Vcarve Pro, Photo V Carve, Cut 3D, scan probe.
Re: My first carve
Thanks for the feedback! I'll give that a try tomorrow.
-
- Posts: 35
- Joined: Sun Jan 15, 2012 2:45 pm
Re: My first carve
Nice! I find putting the text in a vector circle or square then run a pocket path over both and then a profile on just the text gives it a nice look.
here is the .crv with tool paths for the pic.
here is the .crv with tool paths for the pic.
fireresq wrote:I just purchased a CNC Shark Pro Tuesday... heres my first shot at it.
- Attachments
-
- DonationBoxFInal.crv
- (2.48 MiB) Downloaded 200 times