Projects

Browse around for inspiration, or share your work to inspire others!

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
robthowells
Posts: 35
Joined: Sun Jan 15, 2012 2:45 pm

Projects

Post by robthowells »

Some projects I cut and models soon to be cut.
https://www.facebook.com/robthowells/me ... 369&type=3

damonawsgt
Posts: 54
Joined: Thu Jan 22, 2015 1:58 pm
Location: Erin, TN
Contact:

Re: Projects

Post by damonawsgt »

Those are awesome! The majority of the items I have made thus far have been military related. I was wondering if you wouldn't mind sharing how you get it to cut it completely out. I have been using vcarve and the vbit so far. I will run it and then just use either my bandsaw or scroll saw to cut out the design. Thanks in advance.

robthowells
Posts: 35
Joined: Sun Jan 15, 2012 2:45 pm

Re: Projects

Post by robthowells »

Thanks
I run a v-bit profile around the outside for the chamfer then another on the same vector with an end mill with tabs so that it stays put.
I saw it in one of the videos that came with the software. Can't remember which video.


damonawsgt wrote:Those are awesome! The majority of the items I have made thus far have been military related. I was wondering if you wouldn't mind sharing how you get it to cut it completely out. I have been using vcarve and the vbit so far. I will run it and then just use either my bandsaw or scroll saw to cut out the design. Thanks in advance.

Post Reply