Table Saw Inserts

jbyers · Post by **jbyers** » Sat Mar 21, 2015 12:46 pm

The insert around the blade for my table saw broke when it hit the concrete floor... I needed a tight clearance for a 45-deg cut on a narrow project for a friend. I couldn't get the blade low enough to simply make a blank insert and raise the blade through it, so I went to the Shark and made a few custom-sized inserts! I located 4 holes for leveling "feet", threaded them and added nylon set screws. Great way to use one tool to help another tool out

.

tonydude · Post by **tonydude** » Sat Mar 21, 2015 5:58 pm

That is nice. Would you mind posting the file for it. Thanks.

Tony

jbyers · Post by **jbyers** » Sat Mar 21, 2015 10:12 pm

Thanks Tony, I'll put it out there.

gordread · Post by **gordread** » Mon Mar 23, 2015 9:30 am

That table-saw looks like a Rigid. What a great saw, and great inserts.

If you don't mind sharing the crv I'd like to make a couple of these for my Rigid.

Gordon

tonydude · Post by **tonydude** » Mon Mar 23, 2015 10:44 am

They are right here. http://www.cncsharktalk.com/viewtopic.php?f=12&t=4257

Tony

jbyers · Post by **jbyers** » Mon Mar 23, 2015 11:13 pm

Gordon, Thanks! The table saw is a Craftsman.

CNC Shark Forum

Table Saw Inserts

Table Saw Inserts

Re: Table Saw Inserts

Re: Table Saw Inserts

Re: Table Saw Inserts

Re: Table Saw Inserts

Re: Table Saw Inserts