That looks absolutely fab
I have a problem with my Z axis. It is only moving about half the distance it is supposed to do eg
The control board says I have done 3 inches but in reality it has only done 1.934 inches.
It doesn't matter whether there is load or not, the result is the same.
The other 2 axes are OK.
Weird
Lee
The Hangover Part 3
Moderators: al wolford, sbk, Bob, Kayvon
Re: The Hangover Part 3
If you can't blind someone with science, Confound then with B***S***
Re: The Hangover Part 3
That's strange. Piece of wood jambed under Z carriage?
Re: The Hangover Part 3
No, nothing of the sort.BillK wrote:That's strange. Piece of wood jambed under Z carriage?
Even without the router mounted, it is still doing it.
I have a horrible feeling there is something wrong with the stepper motor, I guess that somehow it is only going half speed.
L
If you can't blind someone with science, Confound then with B***S***
-
- Posts: 488
- Joined: Fri Apr 08, 2011 2:14 pm
Re: The Hangover Part 3
Hi lee Let me chime in on this.Are the set screws tight .Then jog it up and down.You can switch motors with another axis.There is nothing to taking it apart.Give it a try.Basecircle