Here is my first attempt at carving lithos.
First off I would like to thank Tony for his help in getting me started. He gave me more than just the basic tips on how I should setup the files and speeds and feeds tips.
Attached is my 3rd attempt. First 2 failed do to feed rate being to fast for the .031 bit I tried. I was 90% done when I snapped the bit. I also snapped a bit on .06 bit as well. I was just trying to cut to fast and paid the price. 2 bits and 2 pieces of 5x7 Candlestone.
I used 5x7 candlestone 1/4 rough side up.
.06 BN
14K RPM
50 Feed Rate
Plunge 20
took me about 2 hours 19 Min to carve.
I have not made a base /frame yet.
Wayne
My First Litho
Moderators: al wolford, sbk, Bob, Kayvon
My First Litho
Aspire 8.024, photo vcarve, cnc Shark 60th, control panel 2.1
Re: My First Litho
So far so good. Make sure you backlit it not from the bottom.
Tony
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.