Page 1 of 1
First Cast Acrylic
Posted: Fri Mar 01, 2019 7:00 pm
by Kulikon
First attempt at a night light for my granddaughter. Used 12inx12inx3/8 cast acrylic, 6o degree v bit, 8000 rpm 200 in/sec cutting 1/10 in.
- base for the electronics
base carved on both sides to make a groove for the acrylic and for the electronics.
- close up of the actual cuts
Re: First Cast Acrylic
Posted: Sat Mar 02, 2019 11:52 am
by gdon_2003
Very cute. You grand daughter should feel safe from the monsters under the bed now. Everyone knows monsters cannot stand light.