Help with wiring Shark controller with Sherline lathe motors

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
dreiii
Posts: 12
Joined: Mon Jun 18, 2012 5:58 pm

Help with wiring Shark controller with Sherline lathe motors

Post by dreiii »

Could anyone point me in the right direction to finding info on wiring a Sherline lathe to the Shark controller. Have had the Sherline for several years and have had several problems with it. Sent back to factory once and that really didn't solve the problem. Now have Shark and found a way to do lathe work with VcarvePro. Hope this is possible, seems simple at first but then it gets complicated for a person with no real training or experience with CNC electronics.

Thanks in advance

Dan
Top
Post Reply

Return to “Setting up the Shark”