Not taking commands from PC

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
gordread
Posts: 175
Joined: Sun Jul 08, 2012 2:02 pm
Location: Onoway, Alberta
Contact:

Not taking commands from PC

Post by gordread »

Hi everyone. I just finished setting up my new Shark Pro Plus HD. Yay!!

The only problem I ran into was my PC wasn't properly talking to the controller.

In the end I reinstalled all of the software, got the USB drivers to install. Finally I updated the firmware on the controller, and everything worked just great.

I just thought that I'd share this as I couldn't find anything on the forum.

Now... on to cutting wood. wooohooo!!

Gordon

Post Reply