Adding bits to data base

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
cnc novice
Posts: 18
Joined: Thu Apr 14, 2016 9:38 am

Adding bits to data base

Post by cnc novice »

I am trying to add some bits to my tool data base this is to say the least confusing. I am adding spiral flute plunge bits I have created a new group but when I go to add the individual bits The new group is not an option in Bit type. Any tidbits of knowledge

Post Reply