Connect Controller to Computer?

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: sbk, al wolford

Connect Controller to Computer?

Postby EMTPJ » Fri Aug 18, 2017 2:39 pm

Greetings.. Setting up my HD4 shark. Got it to power on (took 2 days to figure out that the emergency stop was pushed in from the factory), went to the software on my laptop, and clicked "help/register product" and when I click it, it says to make sure my controller is connected to my computer with my USB cord. So The only USB cord that came with it I plugged the USB end into my computer, and the other end into the front of the controller. What else do I need to do?

I have to say that this is the absolute worst setup instructions I have sever seen on any product in my life. Super disappointed in the initial setup process for this...

EMTPJ
EMTPJ
 
Posts: 2
Joined: Thu Aug 17, 2017 3:26 pm

Re: Connect Controller to Computer?

Postby Kayvon » Mon Aug 21, 2017 10:51 am

Turn everything off. Plug the USB in. Turn everything on. Try the registration again.

took 2 days to figure out that the emergency stop was pushed in from the factory
:D
User avatar
Kayvon
 
Posts: 296
Joined: Tue Oct 21, 2014 11:46 pm


Return to Setting up the Shark

Who is online

Users browsing this forum: No registered users and 1 guest