Connect Controller to Computer?

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
EMTPJ
Posts: 2
Joined: Thu Aug 17, 2017 3:26 pm

Connect Controller to Computer?

Post by EMTPJ »

Greetings.. Setting up my HD4 shark. Got it to power on (took 2 days to figure out that the emergency stop was pushed in from the factory), went to the software on my laptop, and clicked "help/register product" and when I click it, it says to make sure my controller is connected to my computer with my USB cord. So The only USB cord that came with it I plugged the USB end into my computer, and the other end into the front of the controller. What else do I need to do?

I have to say that this is the absolute worst setup instructions I have sever seen on any product in my life. Super disappointed in the initial setup process for this...

EMTPJ

User avatar
Kayvon
Posts: 552
Joined: Tue Oct 21, 2014 11:46 pm

Re: Connect Controller to Computer?

Post by Kayvon »

Turn everything off. Plug the USB in. Turn everything on. Try the registration again.
took 2 days to figure out that the emergency stop was pushed in from the factory
:D

Post Reply