Page 1 of 1

Connect Controller to Computer?

Posted: Fri Aug 18, 2017 2:39 pm
by EMTPJ
Greetings.. Setting up my HD4 shark. Got it to power on (took 2 days to figure out that the emergency stop was pushed in from the factory), went to the software on my laptop, and clicked "help/register product" and when I click it, it says to make sure my controller is connected to my computer with my USB cord. So The only USB cord that came with it I plugged the USB end into my computer, and the other end into the front of the controller. What else do I need to do?

I have to say that this is the absolute worst setup instructions I have sever seen on any product in my life. Super disappointed in the initial setup process for this...

EMTPJ

Re: Connect Controller to Computer?

Posted: Mon Aug 21, 2017 10:51 am
by Kayvon
Turn everything off. Plug the USB in. Turn everything on. Try the registration again.
took 2 days to figure out that the emergency stop was pushed in from the factory
:D