hello everyone ,
my name is Don and I just ordered the shark HD4.
My question is I noticed when I start my table saw the lights dim \ flicker a tad.
Will this mess up the CNC if it is running when I start that saw ?
Thank You
power question ?
Moderators: al wolford, sbk, Bob, Kayvon
-
- Posts: 408
- Joined: Tue Mar 08, 2016 5:23 pm
Re: power question ?
I have the Shark Pro HD3 Extended bed machine in a 10' x 21' workshop with a Window A/C Unit. I have not had any problems when my A/C compressor kicks on during any of my CNC operations during the past two years. The A/C tends to flicker the lights but it has not had any interference with the CNC machine during a project carving. Lights, A/C and CNC are all on the same circuit breaker.
Sharkcutup
Sharkcutup
V-Carve Pro Tips, Gadget Tips & Videos
YouTube Channel - Sharkcutup CNC
V-Carve Pro 11.554
YouTube Channel - Sharkcutup CNC
V-Carve Pro 11.554
-
- Posts: 2
- Joined: Sun May 13, 2018 10:17 am
Re: power question ?
Thank You, I appreciate the information my friend .