Page 1 of 1

power question ?

Posted: Wed May 30, 2018 11:03 am
by Tenderfoot91
hello everyone ,
my name is Don and I just ordered the shark HD4.
My question is I noticed when I start my table saw the lights dim \ flicker a tad.
Will this mess up the CNC if it is running when I start that saw ?
Thank You

Re: power question ?

Posted: Wed May 30, 2018 2:09 pm
by sharkcutup
I have the Shark Pro HD3 Extended bed machine in a 10' x 21' workshop with a Window A/C Unit. I have not had any problems when my A/C compressor kicks on during any of my CNC operations during the past two years. The A/C tends to flicker the lights but it has not had any interference with the CNC machine during a project carving. Lights, A/C and CNC are all on the same circuit breaker.

Sharkcutup

Re: power question ?

Posted: Wed May 30, 2018 4:58 pm
by Tenderfoot91
Thank You, I appreciate the information my friend .