Virtual Zero Between Tool Paths
Posted: Mon Nov 12, 2018 8:52 am
When using different tool paths, how do you set the virtual zero when the depth of the wood changes depending on past cuts. My first tool path is a 3d roughing tool path which will remove up to .25" of material in some spots, mostly in the center of the work piece.When I run the 3d finishing tool path it asks to set virtual zero again. The touch plate will be at different heights as it runs the zeroing process.
I could skip the zeroing process, but then it is near impossible to get the next bit installed at the same height as the first bit.
Thanks.
I could skip the zeroing process, but then it is near impossible to get the next bit installed at the same height as the first bit.
Thanks.