Post processors for shark hd for PhotoVcarve and Cut3d

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Tpellicci
Posts: 2
Joined: Sat Aug 04, 2018 3:59 pm

Post processors for shark hd for PhotoVcarve and Cut3d

Post by Tpellicci »

Trying out photovcarve and Cut3d, but there is no post processor for my Shark HD, any idea. I dropped the one from vcarve in there but get an error for cut3d and it doesn't show up in PhotoVcarve same for the laser file. Any ideas?

tonydude
Posts: 1581
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: Post processors for shark hd for PhotoVcarve and Cut3d

Post by tonydude »

Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

Post Reply