RCA Cables / grounds?

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: sbk, al wolford

RCA Cables / grounds?

Postby CharliesWoodStuff » Wed Feb 06, 2019 3:02 pm

I read in another post that the RCA cables were ground cables. Is this true? And if so (well, either way), does it matter which gets plugged into which port on the back of the controller interface?
CharliesWoodStuff
 
Posts: 23
Joined: Sun Nov 04, 2018 11:57 am
Location: Maysville, WV

Re: RCA Cables / grounds?

Postby OCEdesigns » Fri Feb 08, 2019 7:01 am

No it doesn't matter. I have actually plugged mine in both ways and no issues.
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 9.5
OCEdesigns
 
Posts: 79
Joined: Fri Jan 11, 2019 8:26 am

Re: RCA Cables / grounds?

Postby CharliesWoodStuff » Fri Feb 08, 2019 8:52 am

Thank you.
CharliesWoodStuff
 
Posts: 23
Joined: Sun Nov 04, 2018 11:57 am
Location: Maysville, WV


Return to Setting up the Shark

Who is online

Users browsing this forum: No registered users and 1 guest