RCA Cables / grounds?

Questions/answers/discussion about initial setup of your CNC Shark

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
CharliesWoodStuff
Posts: 24
Joined: Sun Nov 04, 2018 11:57 am
Location: Maysville, WV

RCA Cables / grounds?

Post by CharliesWoodStuff »

I read in another post that the RCA cables were ground cables. Is this true? And if so (well, either way), does it matter which gets plugged into which port on the back of the controller interface?

OCEdesigns
Posts: 105
Joined: Fri Jan 11, 2019 8:26 am

Re: RCA Cables / grounds?

Post by OCEdesigns »

No it doesn't matter. I have actually plugged mine in both ways and no issues.
Shark HD4 Extended Bed, Water Cooled Spindle. VCarve Pro 10.5
Maker of many chips

CharliesWoodStuff
Posts: 24
Joined: Sun Nov 04, 2018 11:57 am
Location: Maysville, WV

Re: RCA Cables / grounds?

Post by CharliesWoodStuff »

Thank you.

Post Reply