Coupler location on 60th Anniversary Edition

Discussion specifically about the Shark's bigger brother, the CNC Shark Pro

Moderators: sbk, al wolford

Coupler location on 60th Anniversary Edition

Postby SCHIRMY13 » Thu Jan 25, 2018 11:27 am

I've been told to check to see that set screws are tightened on the coupler because in a profile toolpath my machine is drifting on the second pass. Does anyone have a pic as to what I'm looking for?

Posts: 1
Joined: Fri Oct 31, 2014 11:48 pm

Re: Coupler location on 60th Anniversary Edition

Postby Rando » Sat Mar 10, 2018 2:33 am

Ack! Sorry we didn't respond sooner. Did you get this figured out? Below are three pix of the three couplers, one on each of the X, Y and Z axes:

If your X-axis runs parallel to the T-track slots, that coupler is under the bed, and not easy to get to.

So, your Y axis runs along the gantry, so that coupler is at the left-hand side where the stepper motor attaches.

And the Z-axis coupler is up underneath the top plate.

They all take a 4mm hex wrench, though a 5/32" will work in a pinch.

The odd white specs everywhere are from the aluminum chips/flakes reflecting the phone's flash :roll:

Hope that helps, and apologies for taking so long. No excuses, we should have done you better.

===================================================== Creative tools and photographic art
A proud member of the Pacific Northwest CNC Club (now on Facebook)
Posts: 514
Joined: Tue Jan 06, 2015 3:24 pm
Location: Hoquiam, WA

Return to Shark Pro

Who is online

Users browsing this forum: No registered users and 2 guests