surface planing bit question

Discussion specifically about the Shark's bigger brother, the CNC Shark Pro

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
milo30
Posts: 553
Joined: Mon Mar 12, 2012 9:21 pm

surface planing bit question

Post by milo30 »

I've seen some of the bits others use with larger routers or spindles for their spoil board. I've been using a 1/4" spiral with the colt but it takes forever. I came across these tonight...http://magnate.net/index.cfm?event=show ... &theID=136

Anyone use anything close to these sizes with their colt? I was just wondering if it has enough power to use one effectively or not. Sure would be much quicker on the spoil board or when I have to glue a couple of boards together.

Post Reply