I have a Bob/Cad program and would like to know if anyone has used the same and subsequently been able to
use the controller for the Shark Pro, and how would you go about using the G code. Are there any specific
problems in doing so?
Bob/Cad to G code
Moderators: al wolford, sbk, Bob, Kayvon
Re: Bob/Cad to G code
Jim,
What version do you have? Here is the website for your post processor. http://bobcad.com/support/post-processors
Tony
What version do you have? Here is the website for your post processor. http://bobcad.com/support/post-processors
Tony
Buffalo,NY
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.
"What will matter is not what you bought but what you built; not what you got, but what you gave”
Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.