Page 1 of 1
Touch Probe
Posted: Sun Oct 27, 2013 6:47 pm
by BillM
I have recently purchased a touch probe for my Shark Pro and confused about the Z scan limits and starting height. I have a simple project where the height is 1 ¾ inches and I have set the Z scan limits to 2 inches. When I set the starting XYZ locations to zero should I start my probe at the height of 1 ¾ inches or 2 inches? I am not sure if I could damage the probe by setting The Z scan limits different than the Z starting height. Thanks for the help
Re: Touch Probe
Posted: Mon Nov 04, 2013 8:39 am
by jeb2cav
Hi Bill,
See if this post helps answer this question -
http://www.cncsharktalk.com/viewtopic.p ... ouch#p6834
Re: Touch Probe
Posted: Sun Nov 10, 2013 8:57 pm
by BillM
Thanks for the help. It worked great,
Thanks
Bill
Re: Touch Probe
Posted: Mon Dec 15, 2014 11:36 pm
by sajjad
I have recently purchased a touch probe for my Shark Pro and confused about the Z scan limits and starting height. I have a simple project where the height is 1 ¾ inches and I have set the Z scan limits to 2 inches. When I set the starting XYZ locations to zero should I start my probe at the height of 1 ¾ inches or 2 inches? I am not sure if I could damage the probe by setting The Z scan limits different than the Z starting height. Thanks for the help
Re: Touch Probe
Posted: Wed May 20, 2015 5:35 pm
by syrulijczyk
great that the answer is here