Shark pro just stopped

Discussion specifically about the Shark's bigger brother, the CNC Shark Pro

Moderators: sbk, al wolford

Shark pro just stopped

Postby martin graphics » Mon May 05, 2014 7:40 pm

My shark just stopped running. Will not go in any direction. The green light on the power supply FS-20024-1M is off but when I disconnect the controller the little green light comes on and shows 24Volts with a meter but doesn't register voltage when the power supply is connected to the the controller. Any Advice. This machine has been running great for years.
martin graphics
 
Posts: 30
Joined: Wed Aug 25, 2010 2:51 pm

Re: Shark pro just stopped

Postby 4DThinker » Mon May 05, 2014 10:00 pm

There is a fuse under the power cord. There should also be a replacement in there as well. Check the fuse.
4DThinker
 
Posts: 949
Joined: Wed Jun 27, 2012 9:00 am

Re: Shark pro just stopped

Postby martin graphics » Tue May 06, 2014 5:20 am

fuse is OK, any other thoughts?
martin graphics
 
Posts: 30
Joined: Wed Aug 25, 2010 2:51 pm

Re: Shark pro just stopped

Postby tonydude » Tue May 06, 2014 12:39 pm

Did you call support at nextwaveautomation? (419) 491-4520

They will help you

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 9.506, photo vcarve, cnc mako shark extended bed, control panel 2.1
tonydude
 
Posts: 1467
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY


Re: Shark pro just stopped

Postby tonybell9699 » Wed May 20, 2015 10:33 pm

Hi, I have another thread on the issues I have had. I received the new controller with a new circuit board only to find (after a few days of heavy use) that the power supply is now bad (lights on, fuze's good, works for a few minutes then stops) Next wave is sending me a new one (mine is still under warranty).

While a pain, they are very responsive, just a slow process.

Tony
tonybell9699
 
Posts: 48
Joined: Sun Oct 12, 2014 9:04 pm


Return to Shark Pro

Who is online

Users browsing this forum: No registered users and 1 guest