Page 1 of 1
Shark pro just stopped
Posted: Mon May 05, 2014 7:40 pm
by martin graphics
My shark just stopped running. Will not go in any direction. The green light on the power supply FS-20024-1M is off but when I disconnect the controller the little green light comes on and shows 24Volts with a meter but doesn't register voltage when the power supply is connected to the the controller. Any Advice. This machine has been running great for years.
Re: Shark pro just stopped
Posted: Mon May 05, 2014 10:00 pm
by 4DThinker
There is a fuse under the power cord. There should also be a replacement in there as well. Check the fuse.
Re: Shark pro just stopped
Posted: Tue May 06, 2014 5:20 am
by martin graphics
fuse is OK, any other thoughts?
Re: Shark pro just stopped
Posted: Tue May 06, 2014 12:39 pm
by tonydude
Did you call support at nextwaveautomation? (419) 491-4520
They will help you
Tony
Re: Shark pro just stopped
Posted: Wed May 20, 2015 5:36 pm
by syrulijczyk
they don't have everytime what you need
Re: Shark pro just stopped
Posted: Wed May 20, 2015 10:33 pm
by tonybell9699
Hi, I have another thread on the issues I have had. I received the new controller with a new circuit board only to find (after a few days of heavy use) that the power supply is now bad (lights on, fuze's good, works for a few minutes then stops) Next wave is sending me a new one (mine is still under warranty).
While a pain, they are very responsive, just a slow process.
Tony