Probably been asked 1,000 times

Discussion specifically about the Shark's bigger brother, the CNC Shark Pro

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
terryz854
Posts: 28
Joined: Sat Aug 01, 2015 7:53 pm

Probably been asked 1,000 times

Post by terryz854 »

I am a brand new Shark HD 3 owner. Am trying to get it setup but the router mount is too low to insert a router bit. I have loaded the VCarve and the control panel software but am stuck as to how to raise the mount without damaging something. Any help? Anyone? Thanks.

User avatar
Bob
Posts: 1252
Joined: Sun Aug 08, 2010 3:35 pm

Re: Probably been asked 1,000 times

Post by Bob »

Terry,
Unless I'm totally misunderstanding your question. Are you trying to move the entire router and mount up?
If so, have you located and tried the jog function on the Shark Control Panel?
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)

Don Key
Posts: 1
Joined: Sat Oct 10, 2015 9:01 pm

Re: Probably been asked 1,000 times

Post by Don Key »

Terry, Did you get it?

terryz854
Posts: 28
Joined: Sat Aug 01, 2015 7:53 pm

Re: Probably been asked 1,000 times

Post by terryz854 »

Thanks Don, got it. Trial and error works the best. Thanks again.

Post Reply