Probably been asked 1,000 times
Moderators: al wolford, sbk, Bob, Kayvon
Probably been asked 1,000 times
I am a brand new Shark HD 3 owner. Am trying to get it setup but the router mount is too low to insert a router bit. I have loaded the VCarve and the control panel software but am stuck as to how to raise the mount without damaging something. Any help? Anyone? Thanks.
Re: Probably been asked 1,000 times
Terry,
Unless I'm totally misunderstanding your question. Are you trying to move the entire router and mount up?
If so, have you located and tried the jog function on the Shark Control Panel?
Bob
Unless I'm totally misunderstanding your question. Are you trying to move the entire router and mount up?
If so, have you located and tried the jog function on the Shark Control Panel?
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)
Re: Probably been asked 1,000 times
Terry, Did you get it?
Re: Probably been asked 1,000 times
Thanks Don, got it. Trial and error works the best. Thanks again.