Page 1 of 1

Probably been asked 1,000 times

Posted: Fri Oct 09, 2015 1:24 pm
by terryz854
I am a brand new Shark HD 3 owner. Am trying to get it setup but the router mount is too low to insert a router bit. I have loaded the VCarve and the control panel software but am stuck as to how to raise the mount without damaging something. Any help? Anyone? Thanks.

Re: Probably been asked 1,000 times

Posted: Fri Oct 09, 2015 6:39 pm
by Bob
Terry,
Unless I'm totally misunderstanding your question. Are you trying to move the entire router and mount up?
If so, have you located and tried the jog function on the Shark Control Panel?
Bob

Re: Probably been asked 1,000 times

Posted: Sun Oct 11, 2015 5:58 pm
by Don Key
Terry, Did you get it?

Re: Probably been asked 1,000 times

Posted: Mon Nov 02, 2015 3:46 pm
by terryz854
Thanks Don, got it. Trial and error works the best. Thanks again.