Page 1 of 1
creating new work piece size with previous job
Posted: Sat May 14, 2016 6:11 pm
by buckeyes66
Was wondering how to use a previous job Example of a sign that is 16 X 16 and make it a 12 X 12 without redoing the complete program. Any help would be appreciated
Re: creating new work piece size with previous job
Posted: Sat May 14, 2016 7:42 pm
by Kevink18
Open the 16 x16 and go to edit than job size position set width and height then check the box scale design with job size click ok. Than on top click on toolpaths in drop down click on recalculate tool all paths. You should be done save the toolpath and start cutting
Re: creating new work piece size with previous job
Posted: Sat May 14, 2016 9:34 pm
by buckeyes66
Thank you so much, I was doing everything but forgetting to click on the scale to size with job size
Re: creating new work piece size with previous job
Posted: Sat May 14, 2016 9:35 pm
by Kevink18
Your welcome