creating new work piece size with previous job

Discussion specifically about the Shark's bigger brother, the CNC Shark Pro

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
buckeyes66
Posts: 3
Joined: Fri May 13, 2016 10:24 pm

creating new work piece size with previous job

Post by buckeyes66 »

Was wondering how to use a previous job Example of a sign that is 16 X 16 and make it a 12 X 12 without redoing the complete program. Any help would be appreciated

Kevink18
Posts: 205
Joined: Fri Nov 23, 2012 3:30 pm

Re: creating new work piece size with previous job

Post by Kevink18 »

Open the 16 x16 and go to edit than job size position set width and height then check the box scale design with job size click ok. Than on top click on toolpaths in drop down click on recalculate tool all paths. You should be done save the toolpath and start cutting

buckeyes66
Posts: 3
Joined: Fri May 13, 2016 10:24 pm

Re: creating new work piece size with previous job

Post by buckeyes66 »

Thank you so much, I was doing everything but forgetting to click on the scale to size with job size
Last edited by buckeyes66 on Sat May 14, 2016 9:35 pm, edited 1 time in total.

Kevink18
Posts: 205
Joined: Fri Nov 23, 2012 3:30 pm

Re: creating new work piece size with previous job

Post by Kevink18 »

Your welcome

Post Reply