New....need help extra small

Discussion specifically about the Shark's bigger brother, the CNC Shark Pro

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Harleymike
Posts: 7
Joined: Wed Aug 04, 2010 11:58 am

New....need help extra small

Post by Harleymike »

Man I feel dumb.....I have followed the tutorial for beginners (Bulls Head) and every time I load the code and run from SD card it seems to run through the code ok but it's only moving the heads a fraction of an inch.....it's like a micro cut or something. Tried a couple of different files and same thing.

Any help or suggestions are greatly appreciated.

Thanks
"Whether you think you can or think you can’t, you’re right".

User avatar
fison
Posts: 102
Joined: Thu Aug 26, 2010 10:24 pm
Location: Tacoma, Washington, USA
Contact:

Re: New....need help extra small

Post by fison »

Mike,

Are you using the right Post Processor for the Shark (CNCShark USB either Inches or Millimeters depending on what you've set everything else to)?

Is everything set to either Inches or Millimeters (both in VCarve and the CNC Shark Basic Panel)?
Paul Fison
Tacoma, Washington, USA
(253) 925-0855

Harleymike
Posts: 7
Joined: Wed Aug 04, 2010 11:58 am

Re: New....need help extra small

Post by Harleymike »

I was saving the file wrong........ :lol: Good to go now.
"Whether you think you can or think you can’t, you’re right".

Post Reply