Page 1 of 1

Safe Z

Posted: Thu Aug 30, 2018 4:24 pm
by rtheademan
Does anyone know how to change the safe Z?

Re: Safe Z

Posted: Thu Aug 30, 2018 4:51 pm
by Kayvon
There's an option for safe Z on the right-hand panel of VCarve in the setup area.

Here's a description on how to use the settings:
http://support.vectric.com/aspire-quest ... -z1-and-z2

Re: Safe Z

Posted: Thu Aug 30, 2018 4:59 pm
by rtheademan
Yes, but it won't let me change it. It is greyed.

Re: Safe Z

Posted: Thu Aug 30, 2018 5:25 pm
by rtheademan
Thank you for your help, I will see if that gets it.

Re: Safe Z

Posted: Fri Aug 31, 2018 6:24 am
by tonydude
Look at this.

Tony

Re: Safe Z

Posted: Fri Aug 31, 2018 10:21 pm
by henry raymond
I’m new but what is the safe Z?

Re: Safe Z

Posted: Sat Sep 01, 2018 8:56 am
by sharkcutup
henry,

This might help

https://docs.vectric.com/docs/V9.0/VCar ... Setup.html
Clearance (Z1)
This is the height above the job at which it is safe for the cutter to move at rapid or maximum feed rate. The software will raise the bottom of the cutter to this height when it traverses the material.
Sharkcutup