Given that I've seen a number of posts about the Bosch router getting hot or dying; I was wondering if it's possible to pause/stop the system to allow the router to cool down then restart to finish the project?
Lame
Stop Router in middle of project
Moderators: al wolford, sbk, Bob, Kayvon
Re: Stop Router in middle of project
Yes, there is. The latest control panel has a PAUSE button and a CONTINUE button that can be used. However, I have only used this to look closer at what is being done without chips flying in my face. You wouldn't want to shut off the controller or the computer obviously.
Re: Stop Router in middle of project
When you say the latest Control Panel do you mean the Shark Control Panel or VCarve Pro?
- Consultingwoodworker
- Posts: 333
- Joined: Fri Jul 02, 2010 7:37 am
- Location: Nashville area
- Contact:
Re: Stop Router in middle of project
The Shark Control Panel. There is a pause button that appears during the program run.
Ralph
Ralph
Re: Stop Router in middle of project
What Ralph said ![Smile :)](./images/smilies/icon_e_smile.gif)
![Smile :)](./images/smilies/icon_e_smile.gif)