Cutting air - NOT

Discussion about the CNC Shark Pro Plus

Moderators: sbk, al wolford

Cutting air - NOT

Postby Hitch » Mon Apr 30, 2018 8:12 am

The router failed, so I replaced the brushes and bearings. Now I'm about 3/4 the way thru an 8 hour carving. Can I restart the carving some place close to where it left off or do I need to start at the beginning?
Hitch
 
Posts: 18
Joined: Thu Nov 11, 2010 5:33 pm

Re: Cutting air - NOT

Postby rungemach » Tue May 01, 2018 2:49 pm

Since you haven't received any replies, I'll jump in...

You most likely have lost your zero position, and would need to reestablish it no matter what you do.

Even If you could get your original zero point established, you might not be able to edit your code to pick a spot where the machine would not be relying on knowing its prior position at that point.

Some CNC software (like Mach 3) has a "run from here" feature that goes through the file to calculate a new starting point at any line in the code. I don't believe the shark can do this.

Being able to re-establish your initial zero point is critical, and then you will have a few hours of air cutting ahead of you. I wish I had a risk free better solution...

If you could find an absolute coordinates point in your code, you might stand a chance of editing out the already run code, but it is not for the faint of heart..

Personally, with that choice, I would let it run for 8 hours if the workpiece was valuable.
rungemach
 
Posts: 451
Joined: Mon Aug 02, 2010 8:24 am
Location: Sarasota, Florida

Re: Cutting air - NOT

Postby Hitch » Fri May 04, 2018 9:29 am

Thank you for your thoughts. I will cut air and have a coffee. I think I may have too big a project for this CNC.
Hitch
 
Posts: 18
Joined: Thu Nov 11, 2010 5:33 pm

Re: Cutting air - NOT

Postby gmm50 » Sat Jun 30, 2018 5:19 pm

We put an hour meter on the router power. I believe we find 625 hours is our limit.
So we see if we can finish each job before we even start.
George
User avatar
gmm50
 
Posts: 39
Joined: Fri May 16, 2014 5:22 pm


Return to Shark Pro Plus

Who is online

Users browsing this forum: No registered users and 1 guest