Stop Router in middle of project

[LAMEIII]

Given that I've seen a number of posts about the Bosch router getting hot or dying; I was wondering if it's possible to pause/stop the system to allow the router to cool down then restart to finish the project?

Lame

[acxsasx]

Yes, there is. The latest control panel has a PAUSE button and a CONTINUE button that can be used. However, I have only used this to look closer at what is being done without chips flying in my face. You wouldn't want to shut off the controller or the computer obviously.

[LAMEIII]

When you say the latest Control Panel do you mean the Shark Control Panel or VCarve Pro?

[Consultingwoodworker]

The Shark Control Panel. There is a pause button that appears during the program run.

Ralph

[acxsasx]

What Ralph said