Page 1 of 1
is this machine adequate for guitar building?
Posted: Sat Jan 08, 2011 11:24 pm
by Justin Cavender
I am considering buying one of these machines for electric guitar building. Does this machine have adequate power for doing this or is this basically a sign making machine?
Re: is this machine adequate for guitar building?
Posted: Sun Jan 09, 2011 7:58 am
by jeb2cav
Hi Justin,
It seems like there are some folks using the Shark to do that. It may require upgrading the VCarve Pro software to Aspire after purchase.
http://www.cncsharktalk.com/viewtopic.p ... itar#p1833
http://www.cncsharktalk.com/viewtopic.p ... itar#p1726
Re: is this machine adequate for guitar building?
Posted: Sun Jan 09, 2011 8:12 am
by Justin Cavender
That is not a problem I have access to mastercam