Using OGEE or Roundover type bits for outer perimeter
Posted: Wed Feb 23, 2011 2:59 pm
I have a question if anyone can recommend which tooling path option to use for using roundover, OGEE or other outer perimeter type bits for finishing touches to outside edges.
As well as what type of tooling path do you create, do you draw a box around the perimeter of the piece and have it trace that or is there some other option.
Any suggestions or comments would be appreciated.
This is for a Shark PRO PLUS using V-Carve 6.0
Thanks
Ken
As well as what type of tooling path do you create, do you draw a box around the perimeter of the piece and have it trace that or is there some other option.
Any suggestions or comments would be appreciated.
This is for a Shark PRO PLUS using V-Carve 6.0
Thanks
Ken