New Ball Screws Quetions:

Discussion about the CNC Shark Pro Plus

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Bruce Tainter
Posts: 3
Joined: Wed Aug 25, 2010 7:08 pm

New Ball Screws Quetions:

Post by Bruce Tainter »

I recently replaced and upgraded my ball screws and the tread is a bit different than the originals. Now my work is running off about an eighth of an inch on X, Y, and Z. How can I compensate for this deviation?

User avatar
Kayvon
Posts: 552
Joined: Tue Oct 21, 2014 11:46 pm

Re: New Ball Screws Quetions:

Post by Kayvon »

You may be able to compensate for that with a custom post processor (tap) file. The control panel software also has some ability to compensate with password 787.
Last edited by Kayvon on Thu Feb 02, 2017 12:58 pm, edited 1 time in total.

tonydude
Posts: 1581
Joined: Tue Aug 17, 2010 9:23 am
Location: Buffalo,NY

Re: New Ball Screws Quetions:

Post by tonydude »

Call support at nextwaveautomation, they should tell you what the ball screw specs are. Tell them what machine you have.

Tony
Buffalo,NY

"What will matter is not what you bought but what you built; not what you got, but what you gave”

Aspire 11.015, photo vcarve, cnc mako shark extended bed with the new upgraded HD 5 gantry with Led pendent.

Post Reply