Mach3 setup

Discussion about the CNC Shark Pro Plus

Moderators: al wolford, sbk, Bob, Kayvon

Post Reply
Ernie34
Posts: 1
Joined: Fri Jul 24, 2015 11:42 am

Mach3 setup

Post by Ernie34 »

I've been looking around and have not found anything on setting up the CncShark Pro with Mach3. I've seen people mentioning that there was a instruction sheet or something but damned if I can find it. I appreciate any and all help.

Thanks,
Ernie

jeb2cav
Site Admin
Posts: 1524
Joined: Thu Sep 30, 2010 7:04 pm
Location: Kentucky
Contact:

Re: Mach3 setup

Post by jeb2cav »

I think that the ability to connect with Mach was only present 'at the very beginning' with the original model of controller. I'm not aware of any ability for the Pro to be used directly with the Mach3 - at least in a supported by NWA fashion.

Post Reply