Page 1 of 1

Mach3 setup

Posted: Sun Apr 15, 2018 9:06 pm
by Ernie34
I've been looking around and have not found anything on setting up the CncShark Pro with Mach3. I've seen people mentioning that there was a instruction sheet or something but damned if I can find it. I appreciate any and all help.

Thanks,
Ernie

Re: Mach3 setup

Posted: Mon Apr 16, 2018 6:38 am
by jeb2cav
I think that the ability to connect with Mach was only present 'at the very beginning' with the original model of controller. I'm not aware of any ability for the Pro to be used directly with the Mach3 - at least in a supported by NWA fashion.