I have a Shark ProPlus with the extruded aluminum table. It is 25 x 36. Are most people using a spoil board? What should the size be for the spoil board? I have a sheet of baltic birch 3/4 plywood that could be used.
Question is that I do not want to trash the aluminum table when cutting through. The
Size of Spoil Board
Moderators: al wolford, sbk, Bob, Kayvon
Re: Size of Spoil Board
Fred,
If you do a quick search of the forum using "spoil board" you will find lots of information on the subject. https://www.cncsharktalk.com/search.php ... poil+board
I prefer to use strips of mdf covering one slot, leaving one slot open, then cover one more...repeat. Counterbore mounting holes in the mdf so bolt heads are below the surface.
Bob
If you do a quick search of the forum using "spoil board" you will find lots of information on the subject. https://www.cncsharktalk.com/search.php ... poil+board
I prefer to use strips of mdf covering one slot, leaving one slot open, then cover one more...repeat. Counterbore mounting holes in the mdf so bolt heads are below the surface.
Bob
"Focus"
Antonie Van Leeuwenhoek (Developer of the microscope.)
Antonie Van Leeuwenhoek (Developer of the microscope.)